Sunday, July 1, 2018

Martian Shelter 2


Okay, last time, we looked at the balloon-type house/shelter. It sounded like a lot of work to get it set up, supported, tied down and covered in sand. Not to mention the care that would be needed to see that it didn’t get any holes poked in it. Would it come with a set of ‘instant bandages’ you could use to patch any accidental holes? Personally, I think I’d make that a condition before I agreed to buy, but maybe that’s just me.

Today, we’re going to look at a slightly different possibility, one that apparently does not require shoveling sand around:

2. An above-ground shelter made from multiple layers of plastic film with low density foam between them. The thinking is that the Martian atmosphere is so thin, it would not ‘suck’ heat from the shelter walls. I’m left wondering about the radiation that was considered omni-present and probably deadly in years gone by. And... really? It’s cold, but it’s a thin cold, so that doesn’t count? Right, and 120° in the desert is hot, but it’s dry, so that’s okay.

Can you show me the Heat/AC power consumption on that type of shelter?

We recently visited the Kennedy Space Center, where the display for Atlantis (shuttle) explained that excess heat was disposed of by running tubes of heated liquid into the shuttle bay doors, which were opened to let that heat disperse. There’s a lot less ‘atmosphere’ in space than on Mars, but heat only gets sucked away when you want it to be, and doesn’t get sucked away when you want to keep it? You have to work at it, either way, and I’m just not convinced flimsy plastic and foam is enough insulation.

Also, I have to assume there is some sort of support system for this ‘tent’. Who gets to put that up? And tie the walls down? Once again, it’s going to need air locks, so will those be pre-fabbed and attached to the ‘walls’ before lift-off? But, since there isn’t any mention of burying it in the sand, would there be sections of the plastic film that would be transparent so the new Martians can look outside and see what the weather is like? Of course, the low density foam in those areas would need to be transparent, also, but I’m doubting that foam could avoid distorting the view.

Well, this is a little mind-boggling, isn’t it? You wanted a cottage to raise a family in, maybe with a picket fence, and all we’ve looked at so far indicates your actual choices are either a balloon buried in sand or a tent that may or may not retain any heat when the wind blows. Buck up, we’ve just begun to look at the possibilities. We’ll find something that’s just right for you.


http://www.imagineeringezine.com/e-zine/mars-makeshelter.html

No comments:

Post a Comment